Measuring for the Patio Pet Door:
determine which height range will work with your slider, open the
slider and measure from the very bottom inside track to the very top
inside track. As you look down on the groove that the slider follows
on the floor, you may see a thin rail. You will want to measure down
past that rail, from the deepest part of the channel on the floor to
the very top inside channel above.
Will These Patio Pet doors fit all Sliding Doors?
you look at the track on the floor your slider follows; you most often
will see a "rail". If this "rail" is narrower than 5/16" (as you look
down on it), then the SB Standard Patio Insert should fit your slider.
What is the Rise?
This is the distance from the bottom of the patio insert to the bottom edge of the pet door frame. The Rise elevates the pet opening. For example a 2" rise will be the same as setting the pet door itself on a 2" block. There are several different rise options available (2", 4", 6", and 8" inches) to accommodate different pets. Selecting the rise along with the proper sized pet opening should result in the opening being higher than the shoulders of your pet to prevent the flap from pinching and also result in an easy step over height that they can use even as they age. As a rule of thumb, a pet opening should be 1.5 - 2" higher than your tallest pet's shoulders.
Included Weather stripping:
Every Security Boss Patio Insert features a replaceable bulb seal that lines both sides of the insert. This bulb seal provides a superior weather seal between the insert and the wall and sliding door. This weather seal can also be replaced if needed very easily by sliding the weatherstripping into the t-slot groove on your patio pet door.
The weather seal is a 3" wide vinyl weather stripping section that attaches to
the back side of your sliding door. When an insert is installed, your
sliding door breaks the seal between the slider and fixed panel. This
weather stripping will seal out any drafts.
Adjustable Height Range:
top section of the Security Boss Patio Pet Door floats on two tension rods that
compress or expand to obtain the best possible fit in the patio door
frame. The top is fit into the upper patio slider track and the bottom
rests on the bottom slider track. Once in place, there are two thumb
bolts that lock the top section into place to prevent the Patio Pet
door from being removed from the outside.
How does my Sliding Door Lock?
We strongly suggest bracing the door with a stick or an adjustable
brace bar; as this immobilizes your slider and is the most effective
way to secure your sliding door. We also offer several locking devices for purchase if your situation requires.
Different ways to Install the Patio Pet Door:
The Security Boss Patio Pet Door can be mounted on the stationary side of the patio
door. Many patio doors have stoppers that normally prevent the
stationary panel from moving. If these stoppers can be removed, the
stationary panel can be moved to accommodate the patio panel.
Note: This technique will not work on patio doors where the stationary panel is molded into the frame.
Use of Extensions Ranges:
makes 4 different height ranges of patio pet doors. You can add 2 inch extensions to the top of all insert heights to extend their reach or adjustment range. These extensions snap into the top of your insert and fit tightly. No screws or hardware are required. It is possible to add more than two (2) extensions on the Security Boss Inserts. The snap in lock feature of the extensions allow for a stable firm unit regardless of the number of extensions are added. This is a great benefit to those who might move to a home with a taller sliding door system.